Nürnberg Rbf clock problem

[Tallos13]

Hi guys!

First of all, thanks a lot for the amazing job y'all have done here in this simulation!

As the title says, today I came across with a clock problem at Nürnberg's Rbf. When I started playing, the simulation time was around 16:00. At around 18:30, I noticed that the time had changed to 04:00. In this point the simulation was running fine but after sending all trains to their destinations, no other (new) train appeared. The train schedule remained the same during the simulation but in the end, there was no train on the field so decided to terminate it. To be honest, I didn't started it again to see if the clock was running OK and I hope it's nothing really big.

Thanks again!

[DevonFrosch]

Hello,

Welcome to Stellwerksim

Such sudden changes in time normally only happen in two cases: after 21:00 (where the clock may jump back to 5 in some cases), or if the local time of the computer is doing something weird.

Did you by any chance change the time of your computer? And which time zone is it set to?

Greetings,
DevonFrosch

[Tallos13]

Hi DevonFrosch!

Thanks for your feedback.

No, I hadn't made any time change before starting the simulation, nor during it (too busy for that in Nürnberg's Rbf ). My PC's time zone is set at +01:00.

Actually it's not such a big deal, I just thought to let you know... I guess if it happens again, I don't have to re-report it as it's an already known issue.

Thanks again for your time!
Tallos