StellwerkSim

How do i create a route for a train, when i press one red button from the start and the red button at destination nothing happens?

Hi,
you need to create the route to each Signal, so you have to click each red button corresponding to the correct signals, therefore creating the route between signals to the required destination. Signals only go in the direction the are facing.

doy1991 hat geschrieben: ↑Mi Apr 07, 2021 5:28 pm Hi,
you need to create the route to each Signal, so you have to click each red button corresponding to the correct signals, therefore creating the route between signals to the required destination. Signals only go in the direction the are facing.

Ok so if i wanted to move train 4627 to platform 3, where would i click?

In this picture, you need to click on the red spots of signal 554, then 551. Next 551, then 542. Next 542 and then 572. All red buttons for signals in the direction of the train.

In general, you cannot create routes that implicitly pass intermediate signals (of the same kind). You cannot use the buttons 554 and 572, because there would be intermediate (main) signals on the route between those two signals.

Shunting signals (like 422, 438) are implicit for routes between main signals, but not for routes between shunting signals.

David